Concrete Mixing Plant Precautions for gear unit installation
Date:2023-02-23 Label：
Concrete Mixing Plant
Concrete Mixing Plant Precautions for gear unit installation
1. Before assembling the Concrete Mixing Plant reducer and mechanical equipment, check whether the Concrete Mixing Plant rotation direction of the output shaft of the reducer is correct;
2. Before the Concrete Mixing Plant reducer is assembled with the source motor and equipment, the Concrete Mixing Plant deviation size of each shaft diameter, hole diameter, key and keyway shall be checked to avoid that the assembly is too tight or too loose to affect the performance of the reducer;
3. The Concrete Mixing Plant reducer must be firmly installed on the mechanical equipment to avoid looseness or vibration;
4. Avoid the
Concrete Mixing Plant gear unit from being exposed to the sun and harsh environment as much as possible;
5. If the
Concrete Mixing Plant reducer is stored for 4-6 months, check whether the oil seal is soaked in the lubricating oil. The oil seal lip may stick to the shaft and even lose its elasticity. Since proper elasticity is a necessary service condition for the oil seal, it is recommended to replace the oil seal;
6. All
Concrete Mixing Plant rubber parts shall not be stained with paint;
7. When connecting with the
Concrete Mixing Plant hollow shaft or solid shaft of the reducer, the
Concrete Mixing Plant matching part of the shaft should be coated with lubricating oil to avoid jamming or oxidation;
8. The
Concrete Mixing Plant oil level must be checked during use (the reducer without special oil filling hole can be ignored);
9. If a new
Concrete Mixing Plant reducer is used,
Concrete Mixing Plant cannot be started at full load, and the load should be increased slowly from small to large;
10. When using various types of motor direct-connected
Concrete Mixing Plant reducers, if the
Concrete Mixing Plant weight of the motor is too large, a support device should be set;
11. Ensure that the
Concrete Mixing Plant motor has a good ventilation environment to avoid affecting the heat dissipation effect;
12. The standard working ambient temperature of the
Concrete Mixing Plant reducer is - 10 ° C to 60 ° C. If not, please contact our technical department.
