The Concrete Mixing Plant Tank Of The Stabilized Soil Mixing Plant Doesn't Work! What Should I Do?

 The Concrete Mixing Plant Tank Of The Stabilized Soil Mixing Plant Doesn't Work! What Should I Do?

⊙ Check whether the Stabilized Soil Mixing Plant  hydraulic oil leaks out (replace the pipe if the pipe is broken, and replace the seal if the seal is broken)!

⊙ Check whether the Stabilized Soil Mixing Plant  radiator fan is rotating, whether the Stabilized Soil Mixing Plant  hydraulic oil is emulsified and whitened, if the Stabilized Soil Mixing Plant  hydraulic oil temperature exceeds 90 degrees, the Stabilized Soil Mixing Plant  hydraulic system will have no pressure, and the Concrete Mixing Plant tank will not rotate! (Don't worry about this situation. Cool the hydraulic pump, hydraulic motor and hydraulic oil with water, and the Concrete Mixing Plant tank can rotate when the temperature drops. Put the materials out, and repair the radiator or replace the hydraulic oil as soon as possible!)

⊙ I didn't pay attention during the transportation, and the jar stopped! The concrete has collapsed and the can can't be turned over! (This may be the case if you feel stressed and can turn a little.)

⊙ Concrete Mixing Plant Engine failure (impossible!!)

⊙ The transmission shaft cross joint is damaged and broken (a is broken, replace a transmission shaft immediately; b is good);

⊙ The Concrete Mixing Plant hydraulic pump is damaged (the condition is a little complicated, with severe internal leakage, and other damages);

The above six conditions are presented, and the concrete is not agglomerated, and the hydraulic motor and reducer are not faulty. The emergency device can be used to drive the hydraulic motor to rotate the tank with the hydraulic pump of another mixer truck, and then the concrete can be released for maintenance!

⊙ The Concrete Mixing Plant hydraulic motor is damaged!

⊙ The Concrete Mixing Plant reducer is broken!!

⊙ Seven or eight situations, emergency devices cannot be used! The inspection cover on the tank can be turned over to discharge the concrete. What to do above the can body

⊙ Concrete Mixing Plant Tower crane and winch can be used to rotate the tank inspection cover to the bottom to release the concrete;

⊙ What should I do if the Concrete Mixing Plant jar gets stuck and doesn't rotate?

⊙ A hole of 50cm square can be cut with gas at the lower side of the tank (pay attention to avoid the spiral blades in the tank, the cut tank wall must be preserved, and the repair is quick, convenient and beautiful), and the concrete can be released.